C. Thermistor
Installation: Check that the thermistor is in contact with the upper
heat roller.
D. Heater lamp
Assembly: Insert the spring (A) into the hole (B) in the fusing frame.
Assembly: Put the paper guide earth spring (A) under the paper
guide (B) before fusing.
Disassembly: There are three pawls on the fusing cover. Remove
the screws and slide the fusing cover to the right to
remove.
The heater lamp is fixed on the fusing cover with a
screw. Slide the fusing cover to the front and remove
the screw, then remove the heater lamp.
Assembly:
Put the fusing harness (A) on the heater lamp (B) as
shown in the figure and fix them together.
Place the fusing harness inside the rib (C).
( 2 )
( 1 )
(A)
(B)
(2)
(1) (2)
(3)
(4)
(3)
(B)
(A)
( 6 )
( 5 )
( 8 )
( 9 )
( 7 )
( 8 )
( 1 0 )
( A )
( B )
( C )
AR-162 [11] DISASSEMBLY AND ASSEMBLY 10/5/2000
AR-162 DISASSEMBLY AND ASSEMBLY – 3