SHARKS SH 18V Li-Ion, Instruction For Operation And Maintenance

Page: 45 / 58

420 774 335 397 www.sharks-shop.cz Stránka 45
OTHER SAFETY INSTRUCTIONS FOR GRINDING AND CUTTING
- Do not handle your hand in accordance with the rotating disc. When the blade moves away
from the hand at the point of cut, a kickback may occur (to rotate the rotating disc along with
the power tool directly on you).
- If the disc is jammed or if you cut the cut for any reason, turn off the tool and keep it
motionless until the disc stops completely.
NOTICE
Never attempt to remove the cutting blade from the cut while the blade is still in
motion.
ADDITIONAL SAFETY INSTRUCTIONS FOR BRUSHING
- Wire bristles are pulled even during operation. Do not overload the wires with excessive
pressure on the brush. Wire bristles can easily penetrate with light clothing or leather.
- The brushes should run at operating speed for at least one minute before using them.
During this time, no one is aged before or in the vicinity with a brush.
NOTICE
Loose bristles or wires can cause injury. Thread the wire drain from the wire brush away from
you. Small items and tiny wires can be launched at high speed and can remain recessed in
your skin.
IMPORTANT WARNINGS
Danger! Never short the battery or expose it to moisture. Do not store it together with
metal parts that could cause short circuits. There is a risk of battery overheating,
eventually burning or exploding.
If you come into contact with acid or similar internal fluid or substance contained in
the battery, immediately wash the affected area thoroughly with plenty of water. If
these substances come into contact with your eyes, rinse thoroughly with water and
seek medical attention immediately.
Do not place the rechargeable battery in fire or water! There is an explosion!
Rechargeable batteries should not be disposed of in conventional household waste
but in a local collection yard in accordance with regulations or handed over to
retailers of "Appliance batteries".
6) Service
●
Have your power tool serviced only by an authorized service center. This will ensure safe
maintenance of repaired power tools. Faulty parts will be replaced by an authorized Sharks
service.
●
Do not attempt to open and disassemble the tool, battery, or charger.
●
Clean the tool only after disconnecting it from the charger. Use only a damp cloth in a mild
detergent solution. In any case, do not use solvents, alcohol, gasoline or other strong
chemicals to clean the product.
SPECIAL SAFETY PRECAUTIONS
Warning! While working, use both hands.
●
This device requires both hands to ensure safe operation and should not be used when
working from a ladder. If a tool is used at a height, a suitable stable platform or scaffolding
should be used.
● Some wooden products can create dust that is hazardous to your health. When using this
device, it is advisable to use an approved dust mask in addition to the dust extraction device.
● Hold your hands outside the cutting area and blade.
● Hold both hands on the saw, do not touch the workpiece.
● Never hold the piece that is cut in the hands or feet. Fix the workpiece on a stable platform