SHARKS SH 18V Li-Ion, Instruction For Operation And Maintenance

Page: 52 / 58

420 774 335 397 www.sharks-shop.cz Stránka 52
PREVENTION OF RETURN
●
Keep the blades sharp and always support them properly.
●
When the saw is stuck in the workpiece, release the switch immediately.
●
Do not remove from the workpiece when the saw is running
●
Never place your hands in front of the saw on the workpiece Fig. 11
● If you hit the reflector, the saw could cause serious injury.
●
It is important to properly support the workpiece and firmly hold the saw to prevent loss of
control that could cause injury.
●
Fig. 12 shows the correct hand position for safety.
● Place a wider section of the saw blade on that part of the workpiece that is strongly
supported, not on the part that is not supported. If the workpiece is short or small, fasten it to
a suitable support.
● Warning! Do not try to hold your hands briefly.
● Fig. 13 shows the correct way to cut the end of the board.
● In Fig. 14 shows a poor process of cutting the end of the board.
● Before setting the tool after finishing the cut, make sure the lower guard is closed and the
disc is completely stopped.
Attention! When making any maintenance, make sure the battery is disconnected from the
device.
Cutting depth at 90 °
Always follow the correct depth adjustment. The correct sheet depth setting for all cuts
should not exceed ¼ inches. Higher depth will increase the chance of a backslash and cause
the cut to be rough. The scale is located on the top cover of the disc.
The circular saw has an adjustable cutting depth. To determine the depth of cut, release the
lever located on the side of the instrument, Fig.15.
Measure the required depth from the base plate to the highest point of the disc or use the
depth gauge on the rigid housing, Fig.16.
Carefully tighten the depth adjustment knob
Cutting angle 0-45 °
To adjust the angle of cut between 0-45 °, release the locking knob, Fig.17.
The motherboard assembly now rotates between 0-45 °. Set the desired cutting angle using
the scale at the front of the machine and tighten the locking knobs.
There are two notches marked 0 ° and 45 ° at the front of the base plate. These notches are
a guide for indicating the position of the disk in relation to the section being executed.
ON and STOP
To start the machine, press the lock switch, Fig.18, and then press and hold the on / off
button, Fig. 19. You can release the safety switch.
To stop the saw, release the switch, the lockable switch will automatically return to its
position.
NOTE: You can press the button from the left or right side.
Always allow the blade to reach full speed and then work with the workpiece.