SharkRF openSPOT, User Manual

Page: 56 / 138

DMR transceiver
55
If the Ignore DTMF commands after 10 secs checkbox is checked, then all
DTMF commands will be ignored after 10 seconds have elapsed since call start.
This is useful to avoid any mistakenly entered and decoded DTMF commands.
C4FM/Fusion® settings
The Default callsign for cross mode calls will be used when a received DMR or
NXDN call does not have a talker alias, or the call's ID doesn't have an
associated callsign in the database (or the database is not available).
If Advanced mode is enabled, the following settings show up:
Allow data calls to network : if enabled, data calls will be forwarded from
the modem to the network. This is not required for normal operation.
Ignore Wires-X® button commands : Wires-X® button commands received
by the modem will be ignored in case this settings is enabled.
Do not convert Wires-X® server names to uppercase : all server names
sent to the transceiver are converted to uppercase by default, and space
characters are replaced with dashes. This conversion can be turned off with
this setting. The conversion is done because some radios (like the Yaesu
FT70) do not show lowercase characters on their displays, and space
characters prevent the radio from saving the current server to a category.
Don't send automatic Wires-X® connect messages : the openSPOT4
automatically sends Wires-X® connect messages in case it connects or
disconnects to/from a server. These automatic messages can be disabled
with this setting.
Hide profiles in Wires-X® "all" reply : if this setting is enabled,
configuration profiles won't be listed on the first page for a Wires-X® "all"
server search.
Auto mute DTMF commands : if a call is ongoing from the modem, and a
DTMF sequence is being entered, and the first character is a Special
command / cross mode private call or Cross mode group call DTMF code,
the outgoing call to the network will be automatically ended, so others
won't be annoyed by hearing your DTMF tones on the same
reflector/talkgroup.
Ignore DTMF commands after 10 secs : if this checkbox is checked, then all
DTMF commands will be ignored after 10 seconds have elapsed since call
start. This is useful to avoid any mistakenly entered and decoded DTMF
commands.
Special command/cross mode private call DTMF code : this code is used as
the first character for entering a control DTMF code, or starting a private
call in cross modes. See more info at each
connector's description , or at the
Control calls section.