11
The P-1 is controllable using a DMX control device, and it can be connected using either a DMX cable or via the fixture’s
built-in LumenRadio CRMX wireless receiver system.
If using a cabled DMX system, connect the DMX IN cable to the input connector and DMX OUT cable to the output. Both connectors
are located on the rear of the fixture’s base (chassis mounted male 5-pin XLR connectors). Terminate the DMX out cable of the last
fixture in the data link.
For outdoor events, use at least IP65-rated XLR connectors.
Connecting a wireless transmitter
The P-1 is designed to look for wireless transmitters in ‘connect’ state, when this option is not yet enabled.
To connect the P-1 to a wireless transmitter:
•
Log off the currently paired wireless transmitter - see “Disconnecting a wireless transmitter” on page 12”.
• Press the connect button on the wireless transmitter.
•
Confirm that the fixture has paired with the wireless transmitter.
Connecting to a DMX control device
Display
Wireless signal strength
Displays the signal strength of the wireless CRMX connection. The wireless signal strength symbol will be flashing if the paired trans
-
mitter is out of range. If no transmitter is paired the symbol will be off.
Current input type
•
When ‘DMX’ is displayed: The fixture responds to data received through cabled DMX.
•
When ‘CRMX’ is displayed: The fixture responds to data received through wireless DMX.
Current DMX address
Displays the current DMX address. The DMX address is altered directly from this view. The next available DMX address is displayed
to the right. The DMX address will flash on no data input.
Current power source / battery level
Displays the current power source, indicated by a power cable symbol or a battery symbol.
Displays the current battery level.
Error Indicator
If any errors are detected, the message ‘ERR’ will be flashing in the display for easy detection.
To read the error message, select ENTER → INFO → ERRORS in the menu.
Shortcuts
•
ESC + ENTER: Press ENTER to confirm factory defaults.
• ESC + UP: Press ENTER to start LED test.
• ESC + DOWN: Press ENTER to unpair CRMX.
•
UP + DOWN arrows simultaneously = flip the display upside-down.
Figure 8: Display view
(113)
DMX
DMX
101
10
(113)
1
DMX
ERR
(113)
Next available
DMX address
Current
Battery level
Wireless
signal strength
Current
input type
Running on
AC power
Current
DMX address
If any errors are detected ‘ERR’ will be flashing
in the display for easy detection.
101
DMX
(113)
Summary of Contents for P-1
Page 1: ...USER MANUAL P 1 P 1 ...
