GB
SGM
Giotto 1500
User’s Manual 1.02
- 57 -
Control of the acceleration of movement speed
Movement can be optimized by changing the speed (SPEED) and
acceleration (ACCEL) parameters, obtaining smooth fast or slow
movements as required.
To optimize movement, proceed as follows:
1.
Use the DIAL to find “SPEED” menu or “ACCELLERATION” menu.
2.
Press ENTER to confirm. The message on the display will start to flash.
3.
Use the DIAL to select the option desired.
4.
Press ESC to confirm.
OPERATING SETUP
4.
Connect Giotto 1500 to the power supply, wait till it has completed reset operations.
5.
Use the DIAL to find the “
PAN-TILT SETUP
” menu. Press ENTER to confirm.
6.
Use the DIAL to select the menu desired among:
OPERATING - LAMP POWER - LAMP CONTROL - RESET CONTROL - SHUTTER CLOSE – FACTORY –
PREVIOUS.
7.
Press ENTER to confirm.
Operating
This function allows to define the resolution of the 8-16 bit movement for
the FOCUS cntrol channel and the indexing channels of the GOBO1 and
GOBO2 wheels.
The difference is in the steps number in which the range of movement of
these channels has to be divided. In 16 bit mode the range of movement
or indexing is divided into 65.536 steps, allowing absolutely smooth and
precise slow movements. The 8 bit mode allows also a good smoothness
and precision on a number of 256 steps. To modify the settings, proceed
as follows:
1.
Use the DIAL to find “OPERATING” menu.
2.
Press ENTER to confirm. The message on the display will start to flash.
3.
Use the DIAL to select the required resolution HIGH RES for 16 bit
mode, LOW RES for 8 bit mode.
4.
Press ESC to confirm.
Lamp power
This Function allows to set the lamp power at 100% (BOOST), at 95%
(NORMAL), at 90% (SAVING) or at 800 Watt (STUDIO).
To enable this function please proceed as follows:
1.
Use the DIAL to find “LAMP POWER” menu.
2.
Press ENTER to confirm. The message on the display will start to flash.
3.
Use the DIAL to select the lamp power desired.
4.
Press ESC to confirm.
SPEED=100%
ACCELLERATION=FAST
LAMP POWER
OPERATING