17
Supported RDM functions
The G-Spot Turbo features support for various RDM functions.
RDM (Remote Device Management) is a protocol enhancement to USITT DMX512 that allows bi-directional communication between
the fixtures and the controller over a standard DMX line. This protocol will allow configuration, status monitoring, and management.
You will need a RDM controller to get control over the supported parameters. See the tables below for supported RDM functions.
RDM functions
Please note:
The RDM controller communicates with the fixtures to show only the available options for each RDM function. The table is subject to change without notice.
RDM
Name
Sensor Type
SMPS PCB
Temperature
Pan PCB
Temperature
Tilt PCB
Temperature
Gobo PCB
Other
Zoom PCB
Other
Base
Temperature
Head
Temperature
Red LED
Temperature
Green LED
Temperature
Blue LED
Temperature
Main PCB
Temperature
Name
Sensor Type
CRMX Signal Strength
Other
Humidity Base
Other
Humidity Head
Other
Fan 1 Led RPM
Velocity
Fan 2 Led RPM
Velocity
Fan Base RPM
Velocity
Fan Head RPM
Velocity
Fan Zoom RPM
Velocity
Errors
Other
Humidity Absolute
Other
Humidity Absolute
Other
PID
Actions allowed
Name
0x00F0
GET / SET
DMX Start Address
0x00E0
GET / SET
DMX Personality / Mode
0x00E1
GET
DMX Personality Description
0x1000
GET / SET
Identify
0x1001
SET
Reset Device
0x0080
GET
Device Model Description
0x0081
GET
Manufacturer Label
0x0082
GET / SET
Device Label
0x0090
SET
Factory Defaults
PID
Actions allowed
Name
0x0200
GET
Sensor Definition
0x0201
GET / SET
Sensor Value
0x0400
GET / SET
Device Hours
0x0401
GET
Lamp Hours
0x0051
GET
Parameter Description
0x0500
GET / SET
Display Invert
0x0501
GET / SET
Display Level
0=OFF, 1 and above=ON
0x8626
SET
Fan 0=AUTO 1=LOW
2=HIGH 3=FULL
Sensors
RDM enables various sensor readouts for remote device monitoring. See the table below for sensors and sensor types.
Please note:
The RDM controller communicates with the fixtures to show only the available sensors for this fixture.
The table is subject to change without notice.
