9
In a stand-alone operation mode the fixture is not running connected to a control device, but it is pre-programmed with a series of up
to 24 scenes, playing continuously in a loop. This program can be set up to run by default whenever the fixture is powered on.
Manual control / Internal sequence editor
The editor option offers the ability to adjust all DMX parameters of the fixture. Each scene has its own DMX settings with the possibility
to define a fade-in time for the transition from the previous scene, and a
wait (static) time, each with a fade time up to 4000 seconds and a wait
time up to 4000 seconds.
The 24 scenes can be preset directly from the control menu of the fixture
by using the editor.
Locate the editor by pressing 'OK' in the menu and selecting 'MANUAL'.
The following option will be available:
• Editor
• Run Program
•
Stop Program
•
Run on power on
•
Capture DMX
The editor of the fixture can also capture capture live DMX values, or
the DMX values can be captured from the controller when using the
‘Control Channel’. The 'Control Channel' can be found in the DMX
charts table, available at http://www.sgmlight.com, or upon request via
[email protected].
To set a single static scene, set the fade time of scene 2 to 0.0 seconds,
this will keep the fixture running scene 1.
To make a sequence of up to 24 scenes, set the fade time of the scene following the last one to 0.0 seconds. This will keep the fixture
looping between scene 1 to the scene before the scene with 0.0 seconds fade time.
The copy/paste function offers the ability to create replicas of a previous created scenes.
Editor
Select Editor by pressing OK. The following options will show up:
• Scene - Press OK and choose a scene (1 to 24). Confirm with OK.
• Wait Time - Press OK and set the wait time (0 to 4000 seconds). Confirm with OK.
• Fade Time - Press OK and set the fade time of the selected scene (0 to 4000 seconds). Confirm with OK.
• Copy Scene - Press OK to copy the selected scene to the clipboard.
• Paste Scene - Press OK to paste copied scene from the clipboard to the selected scene.
• Clear Scene - Press OK to clear the selected scene and set the default settings.
Scroll down in the display to see all controllable features.
To change a value of a feature:
• Select the feature to change
•
Press OK and change the value.
•
Confirm with OK.
Channels operating in 8 bit mode will allow you to set a value from 0 to 255.
Channels operating in 16 bit mode will allow you to set a value from 0 to 65535.
Using stand-alone operation
Figure 7: Stand-alone operation
