20
Replacing a gobo in a gobo holder
GORE-TEX® Membrane
1.
Remove the defective/old gobo.
2.
Place the new gobo with silver side towards the light source.
3.
Align both index marks of the gobo and the gobo holder, as shown below.
4.
Insert the gobo holder and align it with the index mark in the gobo wheel, as shown below.
If necessary, continue replacing gobos one by one as described.
5. If no further service is necessary, reinstall the gobo wheel hatch. To maintain the fixture’s IP65-rating, it is important to fasten
the gobo covers to 1 Nm.
The gobo wheel hatch includes a GORE-TEX® Membrane, which allows the fixture to breathe.
In order to vacuum test the fixture, the GORE-TEX® membrane has to be removed.
For more information on how to vacuum test the G-Spot Turbo, please contact [email protected]
6. Unhook the end of the spring and turn it upwards. Pull the gobo holder out of the gobo wheel.
TORX 20
1
TORX 20
1
Gobo Wheel Hatch 1
GORE-TEX®
Membrane
Figure 11: Replacing gobos in the gobo wheel
Figure 12: Replacing gobos in a gobo holder
Figure 12: Fasten the gobo covers
Figure 13: GORE-TEX
®
Membrane
