SG Security Communications Skyroute UT, Installation Manual

Page: 12 / 30

11
There will be no communication on zones that have exceeded the limit of alarms set in the Swinger Shutdown counter.
Swinger shutdown will be reset every day at midnight or when the panel is armed. Once reset, the panel will again
communicate normally.
Swinger Shutdown ........ Section [370]
4.4 Skyroute Programming Sections....[803]
All programming on the Skyroute transceiver is done in the installer’s programming mode. Once in programming
mode, enter section [803] to access Skyroute programming.
Zone Definition……………………………………………Sub-Section [01]
This section will determine which "event code" will be sent to the Central Station for each zone.
Configuration Options……………………………………Sub-Section [06]
Channel B enable/disable…………..option[2]
This option must be selected when the Cellemetry provider is a “B” side carrier. Must be on in
Canada.
Home System only enable/disable…..option[3]
This option must be programmed to ensure that the Skyroute transceiver is communicating using the
proper carrier. When selected, the transceiver will only use towers with the same SID. (As programmed in
section [07]).
Skyroute Transceiver SID (System ID)…………………..Sub-Section [07]
The chart below lists the different System ID for each of the territories. For proper activation of the
Skyroute Transceiver the correct SID for the territory that you are in must be entered into section [07] in
Hex.
SID Table
System ID in Memco System ID in Memco
Decimal HEX Decimal HEX
16420 4024 Bell Mobility (Ont.) 16390 4006 MT & T Mobility
16418 4022 TB Tel Mobility 16408 4018 NBTel Mobility
16420 4024 Bell Mobility (Quebec) 16414 401E NewTel Mobility
16458 404A Quebec Tel Mobilité 16430 402E Island TelMobility
16422 4026 BCTEL Mobility 16410 401A SaskTel Mobility
16428 402C MTS Mobility 16384 4000 TELUS Mobility
Skyroute Test Time…………………………………………..Sub -Section [10]
Enter in this section the time of the day (Military Time) that you want the test transmission to be sent.
Test Transmission Day Mask…………………………………………..Sub-Section [11]
Select in this section the day of the week you want the test transmission to be sent.
Skyroute Transceiver Test Rates…………………………………………..Sub-Section [13]
Default Option ON Option OFF
OFF I_____I Option 1 Industrial Disabled
OFF I_____I Option 2 Commercial and Business Disabled
ON I_____I Option 3 Residential and Retail Disabled
OFF I_____I Option 4 Keybus Tests Enabled Keybus Tests Disabled
OFF I_____I Options 5 to 8 For Future Use