SG Security Communications Skyroute UT, Installation Manual

Page: 8 / 30

7
Telephone Connection Terminals – TIP, RING, T-1, R-1
If a telephone line is required for central station communication or downloading, connect an RJ-31X telephone jack in
the following manner:
NOTE: Please ensure that all plugs and jacks meet the dimension, tolerance and metallic plating requirements
of 47 C.F.R. Part 68, SubPart F. For proper operation, no other telephone equipment should be connected
between the control panel and the telephone company facilities. Do not connect the alarm panel communicator
to telephone lines intended for use with a fax machine. These lines may incorporate a voice filter, which
disconnects the line if anything other than fax signals are detected, resulting in incomplete transmissions.
Siren Trigger
Use PC1OUT Module Included
ORG
RED
BLK
Bell -
+ 12 volt
GND
Zx1
COM
Zx2
BRG
GND
EMR
Negative Siren Trigger
(Bell + always active and Bell - switch to ground on alarm)
With this configuration, Zx1 will be trigger on
steady Bell and Zx2 will be trigger on pulsed Bell
Positive Siren Trigger
(Bell - always to ground and Bell + switch to + on alarm)
With this configuration, Zx1 will be trigger
every time the Bell is activated
ORG
RED
BLK
Bell -
Bell +
GND
Zx
COM
BRG
GND