8
Pressed key
2nd line on display
Signification
Auto P1 4,7A
Auto P2 0,0A
The pumps are switched on or off, according to the level
requirement. Here, pump P1 is active at the moment.
3.1.4 Parameter setting
The following table shows the setting options and the effects of the individual parameters. A
parameter can be selected via the menu selection
(see point 3.1.1).
For reasons of safety, the modification mode for the parameters can
only be enabled in the "Stop"- operation (key
).
1st line on display
2nd line on display
(set value)
Signification
base load OFF
Base load off ≤ Peak load
off
and
Base load on ≤ Peak load
on
Stop level base load.
Modifications only during Stop-
operation!
base load ON
Start level base load.
Modifications only during Stop-
operation!
peak load OFF
Stop level peak load, 2
nd
pump will switched
off.
Modifications only during Stop-
operation!
peak load ON
Start level peak load, 2
nd
pump will
switched on.
Modifications only during Stop-
operation!
high water
(High water HW)
Peak load on <
HW
and
HW
≤ final value of level
sensor
Flooding- alarm- level
Additionally, this level is constantly
evaluated on the input for the
floating switch HW, independent
from the selected level transmitter.
Thereby, if necessary, 2 different
HV-levels can be realised with 2
different transmitters.
Modification only possible in Stop-
mode !
WARNING
WARNING
