SFA SaniPump, Operating & Installation Manual

Page: 22 / 184

22
Its operating principle is as follows: when the level of effluents contained in the
sump where the SANIPUMP
®
is installed is sufficient, the float switch starts up the
pumping station.
The effluent is automatically pumped to drain into the sewer pipe.
Waste water is discharged :
- by a DN 40 (ext. diameter 50) for SANIPUMP
®
bladed macerator
- by a DN 50 (ext. diameter 63) for SANIPUMP
®
vortex
3.2 Scope of supply
Submersible SANIPUMP
®
pump with float switch, mounting base and pump power supply cable
H05VV-F-3G type 1.5 mm², with a length of 10 metres.
3.3 Rating plate
1 Name of the pumping station
2 Power consumption of motors
3 Power supply voltage
4 Frequency
5 Protection index
6 Production date
7 ID number
3.4 Technical specifications
SANIPUMP
®
Pump specifications
SANIPUMP
®
macerator
SANIPUMP
®
vortex
Flow rate (H = 1 m) 10.5 m
3
/h
27 m
3
/h
Max Height (Q = 0) 14 m
13 m
ON/OFF level 400/100 mm 400/100 mm
Maximum immersion height 5 m 5 m
Activation system Float Float
Thermal overload protection Yes Yes
Power Single phase
220-240 V / 50-60 Hz
Single phase
220-240 V/50-60Hz
Motor consumption 1 x 1,500 W 1 x 1,500 W
Maximum current consumption 6 A 6 A
SANIPUMP
®
pump curve
1
3
4
2
6
7
5
1
3
4
2
6
7
5