SFA OMEGA 21030B, Operating Instructions & Parts Manual

Page: 3 / 24

3
Figure 1 - Typical Jack Nomenclature
SPECIFICATIONS
Model Capacity Jack Size (L x W x H) Min. Height Max. Height Saddle Dia.
21030B 3 Ton 27-1/2" x 13-1/2" x 6-1/2" 5 1/4" 19" 4"
Handle
(release valve)
Saddle
Lift Arm
Oil Filler Plug
(ref. Parts illustration for location)
Caster
Front
Wheel
Handle
Sleeve
Foot Pedal
(model 21030 only)
Before Use
1. Verify that the product and application are compatible, if in doubt call Omega Tech Service (888) 332-6419.
2. Before using this product, read the operator's manual completely and familiarize yourself thoroughly with the product, its
components and recognize the hazards associated with its use.
3. To familiarize yourself with basic operation, locate and turn the release valve (handle):
a. Clockwise until firm resistance is felt to further turning. This is the ‘ CLOSED ’ release valve position used to raise the saddle.
b. Counter-clockwise , but no more than 1/2 turn from the closed position. This is the ‘ OPEN ’ release valve position used to
lower the saddle.
4. With saddle fully lowered, and release valve closed, pump the operating handle. If lift arm responds immediately, jack is ready
for use. If jack does not respond, follow Bleeding/Venting Trapped Air procedure below.
5. Ensure that jack rolls freely. Raise and lower the unloaded saddle throughout the lifting range before putting into service to ensure
the pump operates smoothly. Replace worn or damaged parts and assemblies with Omega authorized replacement parts only.
Bleeding/Venting Trapped Air
With the release valve in the OPEN position (step 3b.) and with saddle fully lowered, locate and remove the oil filler plug. Pump
6 to 8 full strokes. This will help release any pressurized air which may be trapped within the reservoir. Reinstall the oil filler plug.