SEW-Eurodrive MOVIGEAR MGFx-DSI Series, Operating Instructions Manual

Page: 269 / 408

8
Service
SEW‑EURODRIVE Service
Operating Instructions – MOVIGEAR
®
performance
269
4. Compare the data on the nameplates of the old drive unit to the data on the name-
plates of the new drive unit.
INFORMATION
Always replace the drive unit with a drive unit that has the same properties.
In safety-related applications, replace a drive unit only with a drive unit with the same
FS logo.
5. Mount the drive unit. Observe the "Mechanical installation" chapter.
6. Remove the lifting eyes from the new drive unit. Store the lifting eyes for future
service work.
7. Perform the installation according to the "Electrical Installation" chapter.
8. Set all the controls (e.g. DIP switches, see "Startup" chapter) on the new electron-
ics cover in the same way as the controls of the previous electronics cover.
9. Remove the memory module from the old electronics cover. Insert this memory
module in the new electronics cover.
10. Place the electronics cover onto the connection box and screw it on.
11. Supply voltage to the drive.
12. Check the new drive unit for proper functioning.
8.9.4 Installing the lifting eyes
1. Remove the PE connection cable.
2. Install the lifting eye for transportation as depicted in the following image:
5 m
in
X5
13
3_1 X
51
33
_2
2.0 – 2.4 Nm
9007225026665867
8.10 SEW‑EURODRIVE Service
8.10.1 Sending in a unit for repair
If a fault cannot be repaired, please contact SEW-EURODRIVE electronics service
(see "Address List").
Please always specify the digits of the status label when you contact the SEW elec-
tronics service so our service personnel can assist you more effectively.
25887548/EN – 04/2019