SEW-Eurodrive MOVIGEAR MGFx-DSI Series, Operating Instructions Manual

Page: 268 / 408

8
Service
Device replacement
Operating Instructions – MOVIGEAR
®
performance
268
8.9.1 Replacing the electronics cover
1. Observe the safety notes.
2. Remove the screws and take off the electronics cover from the connection box.
3. Compare the data on the nameplate of the previous electronics cover with the data
on the nameplate of the new electronics cover.
INFORMATION
Always replace the electronics cover with an electronics cover with the same type
designation.
In safety-related applications, replace an electronics cover only with an electronics
cover with the same FS logo.
4. Set all the controls (e.g. DIP switches, see "Startup" chapter) on the new electron-
ics cover in the same way as the controls of the previous electronics cover.
5. Remove the replaceable memory module from the old electronics cover. Insert the
replaceable memory module in the new electronics cover.
6. Place the new electronics cover onto the connection box and screw it on.
7. Supply voltage to the drive.
8. Check the new electronics cover for proper functioning.
8.9.2 Replacing the memory module
1. Observe the safety notes.
2. Remove the screws and take off the electronics cover from the connection box.
3. Remove the memory module from the old electronics cover.
4. Insert the new memory module in the new electronics cover.
5. Compare the type designation of the memory module.
INFORMATION
The new memory module must have the same part number as the old memory
module.
6. Place the electronics cover onto the connection box and screw it on.
7. Supply voltage to the drive.
8. Check the startup of the device.
ð
If required, perform startup again or load the saved startup to the device.
ð
For devices with safety card, check the startup of the safety card. For more in-
formation, refer to the "MOVISAFE
®
CSB51A Safety Option" manual.
9. Check the new electronics cover for proper functioning.
8.9.3 Replacing the drive unit
1. Observe the safety notes.
2. Install the lifting eyes to the drive unit, see chapter "Service" > "Device replace-
ment" > "Installing the lifting eyes".
3. Disassemble the drive unit. Observe the notes in chapter "Mechanical Installation".
25887548/EN – 04/2019