SEW-Eurodrive MOVIGEAR MGFx-DSI Series, Operating Instructions Manual

Page: 186 / 408

8
Service
Fault table standard
Operating Instructions – MOVIGEAR
®
performance
186
Subfault: 23.9
Description: Firmware of power section corrupt
Response: Output stage inhibit
Cause Measure
Failed to update firmware on power section. Update the firmware again.
8.7.19 Fault 25 Parameter memory monitoring
Subfault: 25.2
Description: NV memory – runtime error
Response: Emergency stop + output stage inhibit
Cause Measure
Runtime error of non-volatile memory system. – Reset the device.
If this error occurs repeatedly, replace device.
Contact SEW-EURODRIVE Service.
Subfault: 25.6
Description: Incompatible device configuration
Response: Output stage inhibit
Cause Measure
The data set in the device was copied from an-
other device, which differs from the current device
in the device family, power, or voltage. – Check whether the configuration is correct and
repeat the startup, if necessary.
– Acknowledge the fault by manual reset with
parameter set acceptance. Setting under [Dia-
gnostics] > [Status] > [Fault status] parameter
"Manual fault reset".
Replaceable memory module used by another
device. Power rating, device family, or voltage dif-
fers from the current device. – Check whether the configuration is correct and
repeat the startup, if necessary.
– Acknowledge the fault by manual reset with
parameter set acceptance. Setting under [Dia-
gnostics] > [Status] > [Fault status] parameter
"Manual fault reset".
The power section was replaced and differs in its
power rating or voltage from the original power
section. – Check whether the configuration is correct and
repeat the startup, if necessary.
– Acknowledge the fault by manual reset with
parameter set acceptance. Setting under [Dia-
gnostics] > [Status] > [Fault status] parameter
"Manual fault reset".
25887548/EN – 04/2019