Menu Servo
33
The radio has following
channel types:
•
Servo
• Pump –0->
•
Valve
• 5 Pos Servo
•
Sound
• Voith Schn.
•
Max
• Switch
•
Motor
•
Pump 0--->
•
Cruise ctrl.
with constant speed not fast at first and then
slower like with a filter function of the control.
Caution:
The transmission of multi-
switch channels is delayed. Some
multiswitch decoders slow the servos down
as well. The value might not have a visible
effect in that case.
Pump lag [Lag <s>]
just for channel type
[Pump]
The pump lag sets how long a hydraulic
pump runs after the last actuation before
turning off automatically - the maximum is
30 seconds. With a value below 0 the pump
is constantly on (can only be switched off
with emergency off).
[Switchoff]
only for the channel type [Valve]
Time (in seconds) the channel needs to be
in neutral position before the servo signal
switches off at the receiver.
Valve [Backlash]
only for channel type [Valve]
Hydraulic valves often need a certain deflec-
tion to react. With backlash compensation
the hydraulic valves react directly even with
small control movements.
•
Two controls with a maximum control
deflection of +70% mixed (together
+140%) and an endpoint value of 120%
equals a servo deflection of 120% - the
endpoint value limits it.
Tip:
Always adjust the mechanics first
and only make small adjustments with
your radio. If values under 80% seem
to be necessary for a servo it is advisable to
rethink the steering and place the rod further
inwards at the servo. If the deflection causes
problems in one direction only you can
mount the steering arm a little rotated.
Otherwise you lose torque / power!
[Half Left, Half Right]
only for the Channel
type [5 Pos Servo]
Sets the servo position for halfway control
deflection.
[Threshold L, Threshold R]
only for the
Channel type [Switch]
The left and right threshold where the
channel value changes from Middle to Left
or Right
[Channel name]
Here you can assign a name to each
channel. If you didn’t name the channel the
radio shows the channel type instead.
[Speed <s>]
for several channel types
The speed determines how long it takes the
servo to move from 0 to 100% deflection.
For full servo speed set the value 0,0s. At a
value of 3,0s the servo needs about 3
seconds to the endpoint. The servo moves
Channel types