Menu Receiver
23
Green Button [Menu] > [Receiver]
Caution:
The adjustments always
relate to the selected model
!
Menu buttons
[OK]
Green
Back to the higher-level menu.
[Reset]
Red
Deletes all settings on this page and
restores the factory settings. The binding
with the receiver remains.
[CARD]
Yellow
Activates the DisplayCARD Menu to change
CARD settings for all modules that are
connected to the receiver. In the Menu use
the blue button to switch between master
and slave receiver.
For details see chapter
DisplayCARD via radio
Softkeys
[Bind]
By binding
radio and receiver connect.
It
is like they exchange numbers once to find
each other again in the 2.4GHz frequency
band. Only after binding successfully the
receiver reacts to the radio.
At the receiver you need to remove or set a
jumper and then switch the model on -
check the steps according to the receiver
manual.
Press the button [Bind] so the radio
searches for the receiver. If the search is
successful they connect and the number of
the receiver is stored in the model memory.
This binding is necessary only once but can
be repeated as often as you like e.g. if you
put the receiver in a different model.
[BEC threshold]
The Servonaut Zwo4 receivers monitor the
supply voltage of the servos.
If the
voltage falls below the preset value there is
an alarm. Normally it is set at 4.6 Volt. If it
falls lower the receiver or servo supply
voltage may be overstrained. To switch the
monitoring off press both adjust-softkeys at
the same time.
[Battery type]
The Zwo4 receivers can also monitor the
battery supply voltage
if the receiver is
connected to the battery - see the receiver
manual for more information.
There is an alarm for low voltage as well -
the [Battery threshold]. To make the adjust-
ments easier you can select the battery type
with the left softkey and the number of cells
with the right softkey for [Battery type].
[Battery threshold]
Lets you adjust the threshold for the battery
monitoring. Select one of the recommended
values with [Battery type] and fine-tune
them if you like. To switch the monitoring off
press both adjust-softkeys at the same time.
[E4/E6/E9/E18]
Activate this option if you use one of these
Servonaut receiver Zwo4E4, Zwo4E6,
Zwo4E9 or Zwo4E18.
10.2 Menu Receiver
Binding