SEON Trooper TL2, Installation Manual

Page: 8 / 84

Installation
1–4 700-0099 R008
1.3.2. TL2 Installation Diagram
Figure 2 Typical TL2 System
Explorer® TL2
Typical System Setup
Vehicle Electrical Interface
Peripherals
Seon System
Supports Two Cameras
GPS Receiver
*1
Adapter
Harness
*2
Red - Not used
Green - Speed sensor high
Black - Speed sensor low
3 wires
SPEED
Alarm Switch
*1
For speed tracking, use a GPS receiver or speed harness. For ease of installation and better speed tracking, Seon recommends using a GPS receiver.
*2
The Diagnostic Button and alarm input harness are optional and require the adapter harness.
*3
An optional Laptop can be used from the Ethernet outputs located on the front panel.
*4
An optional Video Monitor can be used from the video outputs located on the front or back panel.
To DVR GPS Input
To DVR
ALARM
INPUT
To DVR
Camera
Inputs
To DVR SIGNALS Input
TL2 DVR Rear Panel
Portable Video Monitor *
4
Diagnostic Button
Optional Accessories
Laptop *
3
To DVR VIDEO OUT
To
Adapter
Harness
DIAGNOSTIC
Input
To DVR
ETHERNET
Input
Smart-Reach Lite
(Wi-Fi)
Smart-Reach
Cellular
Modem
To DVR
POWER
Input
1x5 Microfit
DIAGNOSTIC BUTTON
Black - Left Turn
Green - Stop
Red - Brake Signal
Brown - Warning
White - Right Turn
5 wires
SIGNALS
Red - V 12V
5A
3 wires
Yellow - Vehicle Sw 12V
Black - Battery Negative
POWER
1A