SEON Trooper TL2, Installation Manual

Page: 58 / 84

DVR Configuration Menus
4–8 700-0099 R008
Wake The wake on alarm feature is available only for alarm 1.
When enabled, this feature causes the system to power up and
start recording when Alarm 1 is triggered. The system takes
about one minute to power up and start recording, depending on
environment conditions.
Configure Alarm 1 as follows:
1. Select Alarm 1.
2. Set the Alarm Duration (1, 5, or 10 minutes).
3. Set the Alarm Input to N.O or N.C
If programming this line as normally open (N.O.), the red
wire can attach directly to the 12V trigger, no further
connections are required.
For example, if the alarm input was connected to interior
lights of the vehicle, the wake function would occur when
the lights are turned on. If the lights remain on, the DVR
will still only record for the duration specified in the Alarm
menu.
If programming this line as normally closed (N.C.) the red
wire must remain at ground when off and trigger on with
12V.
For example, if the alarm input was connected to interior
lights of the vehicle, the wake function would occur when
the lights are turned on. If the lights remain on, the DVR
will continue to record, repeatedly triggering Alarm 1.
Do not use this setting if e-mails are to be sent based on
Alarm 1.
This input CANNOT be left floating, and must be pulled
back to a 0 VDC low condition via external resistor or
relay.
4. Set the pre-alarm record duration (Off, 5 sec, 10 sec.).
5. Set the Email option (On, Off).
6. Set the Wake option to On
IMPORTANT
: If you are using the alarm button and cable, and
wish to use the Wake feature, the alarm button cable must be
rewired as follows:
• On the alarm button cable, cut the green wire just before it
enters the socket.
• Extend and connect the green wire from the alarm button
cable to an input wire on the signal input harness.
[Off], On
Table 5 Alarm Settings Configuration Items
Menu Item Description Value [Default]