Mains AC Power Supply
AC supply to the ROBOT/SHOP/SCAN POS 3/4/5/6/7 system should be a
dedicated feed from the main switchboard. Do not connect any other
equipment to this feed or damage to the POS terminal or its peripherals may
result. A hint is to clearly identify each POS terminal power outlet as a
dedicated point. The supply should have a reliable ground at the switchboard.
Configuration
Any number of methods can be used to install the ROBOT/SHOP/SCAN POS
3/4/5/6/7, dependant on countertop configuration, user preference and
peripherals connected. It can simply sit on the countertop, in which case care
must be taken to ensure it cannot be knocked off the countertop when
bumped. It can be fixed to the countertop using the mounting plate provided or
mounted on a stand over an embedded scanner. It would be impossible to
cover every installation situation in this manual so each should be considered
individually.
3.2 Mounting
The ROBOT/SHOP/SCAN POS 3/4/5/6/7 is supplied with a mounting panel,
which can be used to secure the ROBOT/SHOP/SCAN POS 3/4/5/6/7 to either
a wall or countertop. If mounting on a wall care should be taken that the fixing
material can take the weight of the POS terminal.
1. On either side of the mounting panel are "buttons" used to lock the
mounting panel to the ROBOT/SHOP/SCAN POS 3/4/5/6/7. Press in the
lower and upper buttons as shown. Then lift the ROBOT/SHOP/SCAN POS
3/4/5/6/7 from the mounting panel.
17
