![background image](http://html1.mh-extra.com/html/sennheiser/l-1039-10/l-1039-10_instruction-manual_1239975009.webp)
Charging the receivers
8
|
L 1039-10
Charging the receivers
왘
Insert the bodypack receiver/transmitter with the BA 2015 accupack installed
into any of the charging compartments
until it locks into place with an
audible click.
The accupack is being charged. The status LEDs
indicate the charging
process.
When an accupack is fully charged, the charging process stops automatically.
Accupacks that are left unused for extended periods of time lose a percentage of
their electrical charge. This is independent of whether the bodypack receivers/
transmitters are stored in the charger’s charging compartments or not.
To make sure that you always use fully charged accupacks, we recommend the
following steps:
왘
Fully charge the accupacks for about 4-5 hours before use. Recharge the accu-
packs every 2 months at the latest.
If you store the bodypack receivers/transmitters outside the charger:
왘
Insert the bodypack receivers/transmitters into the charger as desribed above.
왘
Switch the charger on.
If you store the bodypack receivers/transmitters in the charger’s charging
compartments:
왘
Switch the charger off and on again.
When the status LED
of a charging compartment lights up green, the accupack
of the corresponding bodypack receiver/transmitter is fully charged.
When the status LED lights up red, the accupack is being charged.