Construction Notes:
Please take your time and do a good thorough job of assembly. It may take 2 hours.
Assemble in a location that is flat with plenty of working space to lay components out where they can be easily identified. Place small
parts in a bowl. Protect all work surfaces from damage.
Stainless Steel Screws are SOFT. Maintain constant pressure when fixing these screws to prevent stripping the head of the screw.
Always PRE DRILL HOLES to the correct depth and width 4 mm when indicated to do so in the instructions. If you do not, you will
SPLIT the plywood.
DURING CONSTRUCTION THE TRAINER IS DESCRIBED FROM THE BACK LOOKING FORWARDS
1:
Take the RIGHT hand side panels (2 Parts). Take 2 Hinges and 12 x 4 x16 screws. Place the RIGHT parts together as shown and
place the hinges inside the guidelines. Use one of the RB or LB batons to make sure the back edge is aligned / flush.
2:
Place and align the hinges with the join which should be closed. Fix the middle screw on one side of the hinge first and then
place the second screw in the opposite middle hole a little (1 mm) OFF CENTRE (towards the long edge of the hinge) This will pull
the join closed when you drive the screw into the hinge. Repeat on the other hinge. Then repeat and fix all other screw points