The final component is the removable BOLT COVER “T” with the T Nut in the centre. This is used on the TOP bolt when the BOLT
THREAD protrudes more than 5 mm through the LEFT side panel. It MUST BE USED or you risk damaging you clothes / shoes /
lower body! Before moving onto the next stage make sure the Landing platform can slide.
For ease of description the process of fitting a wheel is shown without the rest of the bike attached. Reminder: For Illustration
we are using a 29 er wheel which is 56 mm wide.
INSTALLING THE BIKE / WHEEL AND ADJUSTING THE TRAINER TO FIT
14:
The bolts are already set in 29er position from our example above.
Ensure the tyre has at least 25 psi
. In some cases, you
may need more.
Place the wheel in the trainer. Slide the RIGHT Side panel across to rest against and trap the wheel. Wind the REAR bolt into the
T nut until you get to the desired width. You can use the markers on the Deck Supports to help. You can always make fine
adjustments later. When you are happy wind the nuts in opposite directions to trap the washers against the LEFT and RIGHT side
panels. This prevents the side panels from moving.