Sencor SWS 7300, Instruction Manual

Page: 6 / 19

EN - 6
WIRELESS SENSOR SIGNAL RECEIVING
1. In normal mode, press [SENSOR] key once to start receiving the sensor signal of
current on displaying channel. The signal icon will flash.
For example, when CH 2 is displayed, pressing [SENSOR] key will start receive for
CH 2 only.
2. The signal icon will flash until the reception succeeded. If no signal is received within
5 minutes the icon will disappear.
Receiving wireless signal after manual reset or the [SENSOR] key is pressed
D/M M/D
M/ D
When waiting for signals, “--” will display in the readings field
D/M M/D
M/ D
Good wireless sensor signal
D/M M/D
M/ D
1. If the signal for the current channel has discontinued
and does not recover within 1 hour, the signal icon will
disappear.
The temperature and humidity will display “ Er ” for the
corresponding channel.
2. If the signal does not recover within 48 hours, the “ Er ”
display will become permanent you need to replace
the batteries of “ Er ” channel’s sensors and then press
[SENSOR] key to pair up the sensors of each “ Er ” channels
again.
NOTE:
After replacing the batteries of the wireless sensor or the unit fails to receive wireless
sensor signal of a specified channel. During the failed channel is displaying, press
[SENSOR] key to manually receive that sensor signal again.
VIEW CHANNEL OF MULTIPLE WIRELESS SENSORS
This main unit can support up to 8 additional wireless sensor(s).
1. If you buy the additional wireless sensor(s) and paired with the main unit. Then, you
can press [CH / +] key to switch the display between CH 1~8 .
2. In normal mode, press and hold [CH / +] key for 2 seconds to enter auto-cycle mode,
after a bi sounds, it will alternately displays the channels at 4 second intervals.
3. During auto-cycle mode, press [CH / +] key once to stop auto-cycle and display the
current channel.
4. Using auto-cycle mode will only display the communicated channels. For example,
when CH 1 and 6 have received the signal from the corresponding sensor, press and
hold [CH / +] key for 2 seconds will only toggle the readings of CH 1 and 6 . Other
channels will be neglected.
D/M M/D
M/ D