Sencor SWS 7300, Instruction Manual

Page: 5 / 19

EN - 5
NOTE:
- The bundled wireless sensor can receive the Radio controlled clock signal for main
unit auto time setting. Just pair up the sensor with main unit to apply this function.
- Once the channel is assigned to a Wireless Hygro-Thermo sensor, you can only
change it by removing the batteries or resetting the unit.
- Avoid placing the sensor in direct sunlight, rain or snow.
MAIN UNIT
Install backup battery
1. Remove the battery door of the main console.
2. Insert the new CR2032 battery as per the polarity information marked on the battery
compartment
3. Close the battery door.
Power up console
1. Plug the power adapter USB plug to
power up the main unit.
2. Once the main unit power up, it will enter
normal time mode.
D/M M/D
M/ D
USB cable
TABLE STAND INSTALLATION
The unit is designed for desktop or wall mount for easy viewing. follow the steps below to
hook the table stand on the botton of the console.
D/M M/D
M/ D
Step 1 Step 2
NOTE:
- If no display appears on the LCD, press the [RESET] key by using a metal wire.
- To avoid the wireless sensor and main unit pairing fail, please power up the sensor(s)
first, and then press
[RESET]
key in main unit after sensor setup.
- You may not receive the signal immediately. Due to the atmospheric disturbance, the
best reception often occurs during night time.