11
2. Getting Started
This chapter describes how to set up and configure the UPSLink.
-
2.1 Panel layout
explains the layout of the panel and LED indicators.
-
2.2 Connecting hardware
describes how to connect the power, the network, and the UPS to
the UPSLink.
-
2.3 Accessing the UPSLink
describes how to access the console port using a serial console or
a Telnet or Web menu from remote location.
The following items are required to get started.
- A power adaptor and a cable (included in the package)
- A console cables (included in the package)
- An Ethernet cable.
- A PC with Network Interface Card (hereafter, NIC) and/or a RS232 serial port.
2.1. Panel layout
2.1.1. UPSLink panel layout
The UPSLink 100 has six LED indicator lamps to display the status, as shown in
Figure 2-1
. The first
three lamps on the upper side indicate Power, Ready and Serial Rx/Tx interface. The next three lamps
are for Ethernet 100Mbps, Link and Act.
Table 2-1
describes the function of each LED indicator lamp.
Figure 2-1 The panel layout of the UPSLink 100
