15
Welcome to UPSLink configuration page
Current time
: 2003/07/09 14:20:42 F/W REV. : 2.2.1
Serial No. : UPSLINK-03040001 MAC Address
: 00-01-95-04-20-30
IP mode
: DHCP
IP Address : 192.168.14.7
-------------------------------------------------------------------------------
Select menu
1. UPS configuration
2. Network configuration
3. Serial port configuration
4. System Status & log
5. System administration
6. Save changes
7. Exit and apply changes
8. Exit and reboot
<ESC> Back, <ENTER> Refresh
----->
Figure 2-5 The main menu screen
From the main menu screen, the user may select the menu item for the configuration of the UPSLink
parameters by typing the menu number and pressing the [ENTER] key. In the submenu screen, users
can configure the required parameters guided by online comments. All the parameters are stored into
the non-volatile memory space of the UPSLink, and it will not be stored until users select menu
‘
6.Save changes’
. All the configuration change will be effective after selecting the menu ‘
7. Exit and
apply changes’
or ‘
8. Exit and reboot’.
2.3.2. Using Telnet
The IP address of the UPSLink must be known before users can access the UPSLink via Telnet (see
chapter
4. Network configuration
for details). The UPSLink is shipped in DHCP mode by default.
The Remote console access function can be disabled in the Telnet access and IP filtering option
(See section
4.5 . Access control
for details).
The following instructions will guide you to access the UPSLink via Telnet.
1) Run a Telnet program or a program that supports Telnet functions (i.e. TeraTerm-Pro or
HyperTerminal). The target IP address and the port number must match the UPSLink. If
required, specify the port number as 23. Type the following command in the command line
interface of user’s computer.
telnet 192.168.14.7 (under assumption that the IP address of the
UPSLink is 192.168.14.7)
Or run a Telnet program with the following parameters:
