508.366.1488 | www.semshred.com
3
Disintegrator Safety Rules
1.
Read entire manual prior to installation or initial operation.
2.
Observe and follow your company’s safety policy regarding disintegrating equipment.
3.
MOVING OR LIFTING THE DISINTEGRATOR
: Care must be taken when moving the machine along the floor or
when lifting it. Damage may occur to sheet metal covers, electrical cabinets, or small brackets if pressure is
applied to them when moving the disintegrator. When lifting the disintegrator, be certain of total machine
weight and the capability of the lifting equipment.
4.
Always disconnect and perform lockout tagout (LOTO) when disconnecting the main electrical power to the
disintegrator before performing any service.
5.
SAFETY INTERLOCKS MUST NOT BE BYPASSED
. The mechanical and electrical safety interlocks ensure the
safety of personnel. They should never be tampered with or removed for ANY reason. They should be frequently
checked by a qualified mechanic for proper operation.
6.
DISINTEGRATOR LOCATION
: Provide an adequate area for routine maintenance that allows machine to
be opened for service.
7.
SAFE HOUSEKEEPING:
The work area should be kept clean and uncluttered to allow personnel safe
movement around the disintegrator during periods of operation or maintenance. No hand or power tools should
be left on or about the machine. Any tools or other metal objects which mistakenly fall into the hopper feed
opening can cause severe damage to internal screen chamber and cutting chamber components.
8.
SAFETY GLASSES OR A FACE SHIELD MUST ALWAYS BE WORN
when operating or servicing the machine.
Although SEM machines are designed for the maximum in fly back control, caution must be used when
operating near the area of the hopper feed opening in order to guard against unexpected material fly back.
9.
EAR PROTECTION
may be required when operating the machine during disintegration of very hard/noisy materials.
The Occupational Safety and Health Act of 1970 (OSHA) has established guidelines for permissible noise
exposures (1910.95) that should be followed. Each site should determine their own requirements for PPE.
10.
NEVER
operate the disintegrator unless it is fully assembled with all guards and interlocks in place and functional.
11.
Observe all danger, warning, caution, and safety labels on the equipment.
12.
Upon completion of any machine maintenance, be certain all safety guards and covers
are securely and
properly fastened prior to resuming machine operation. Failure to secure and tighten all safety guards and
covers may result in injury to personnel and equipment.
13.
NEVER
wear any loose fitting clothes, neckties, or dangling items such as earrings, belts, or shoestrings. Jewelry
such as wristwatches, bracelets, or rings should
NEVER
be worn. Long hair must be tied back or placed
within a tight fitting hairnet.
NEVER
lean against or rest hands/feet on the disintegrator when it is in operation
or opened for maintenance.
NEVER
stand on the disintegrator when it is in operation.
14.
ROTATION OF MOTORS:
All rotating items in the disintegrator are clearly marked on the machine. Always check
for proper rotation of motors.
15.
ELECTRICAL GROUNDING:
All electrical equipment on the disintegrator must be grounded in accordance to
all local codes and Article 250 of the National Electric Code.
16.
NEVER
modify the machine configuration or any individual component.
