5
OPERATION
CHILD SAFETY - INSTALL TENSION DEVICE
WARNING
To avoid entanglement and strangulation,
keep cords out of reach of young
children
. Move cribs and furniture away from shade cords.
TENSION DEVICE
The tension device reduces the hazards of strangulation and entanglement of young children by limiting access to the
control cord.
The cord tensioner must be installed to make the shade fully operable.
Read the instructions in the mounting hardware packet prior to installing the tensioner.
SAFETY LABELS
In compliance with WCMA/ANSI safety standards, the warning labels on the bottom rail are designed to be permanent.
DO NOT
remove the permanent warning label on the bottom rail. This assures that future owners of this product will be
aware of potential dangers associated with this shade.
Pulling down on the back cord will lower the shade. Pulling down on the front cord will raise the shade.
If shade was ordered as a reverse roll, the front cord will lower the shade and the back cord will raise the shade.
SKEW ADJUSTMENT (IF NECESSARY)
If the shade does not raise evenly, first make sure the mounting
brackets are mounted level with each other.
If the shade is level and it still skews, operate the shade to
the full down position. Prepare a strip of masking tape
approximately 5” long. On the side of the shade opposite of
the skewing direction, and as close to the end of the roller as
possible, lift the fabric toward the back of the shade using your
fingers and slide the tape with the sticky side facing the roller
up as far as possible. The tape should be running parallel to the
roller.
Roll the shade up and check for skewing. If the shade is still
skewing, add another strip of tape on top of the first one. If the
shade is now skewing in the opposite direction, tear off about
1” of tape from the last strip installed. Tear the tape off the end
closest to the center of the shade.
Place tape at this end
