11
If using a timer remote, tap the MODE button until you see “MANUAL” in
the display.
The lower and upper limits have been set at the factory. If you need to make
adjustments to the limits, follow the instructions below.
Please Note: When clearing the factory set limits, both the upper and lower
limits will need to be reset.
Use the
CHANNEL
buttons to select the channel for the shade that needs to be
adjusted.
If there is only a single shade on the channel, proceed to setting limits on the
next page.
If there is more than one shade on the channel, all shades will need to be
unlinked. Press and release the
CONFIRM
button. Continue to press and
release until the shades jog.
All shades previously linked to selected channel will now be unlinked.
Follow the steps in STEP 3: LINK REMOTE found on pages 5-7 to link only the
shade that needs to be adjusted.
Follow the limit setting instructions on next page and then relink “turned off”
shades by following the steps in STEP 3: LINK REMOTE found on pages 5-7.
ADJUST MOTOR LIMITS (IF DESIRED)
