Selden Furlex Electric, Supplementary Manual

Page: 39 / 52

39
4.
Position the connection as high as possible
in the anchor box.
Adjust the length of the cables so that a loop
is formed as shown. This will create a lowest
point of the cables preventing water from
running towards the connection box.
5.
Cut the cables and feed them through the
cable gland nut and the rubber seal insert.
Strip the cable ends and connect them in
pairs to the screw terminals.
Tighten the nut, compressing the seal
around the cables.
6.
Repeat steps under point 5 for cables to be
connected to the MCU inside the boat.
Seal insert