Selden Furlex Electric, Supplementary Manual

Page: 35 / 52

35
7.
Check that the motor unit fits over hub.
Check that the two locking screws (G) fit.
Note that motor unit can be turned 90°
depending on the direction of the forestay
fitting in the boat. Verifying what holes are
to be used at this point will help facilitate
assembly in the boat.
Finer adjustment can be made by loosening
the locking nut (N) of the fork terminal and
turning the fork. This adjustment also affects
the distance between deck and forestay
attachment - see point 8.
Remove screws and motor unit.
8.
Fit the swivel in the boat without the motor
unit, to control following points:
a) Distance between forestay and deck.
The distance between tack ring and deck
fitting should be approx. 5mm at the front
when eye of tack-ring is pulled upwards.
If the distance needs to be adjusted, follow
the instructions in chapter 3.2, manual
597-418
b) The position of the motor unit relative to
the fork, which determines the position of
the motor unit in the boat.
Example: if motor unit is turned slightly
clock-wise, access to the emergency
socket will improve.
If holder (H) cannot pass the fork,
adding chamfers on fork might
be necessary. Use a file and add
approx. 3x45° chamfers at four
places (J). Do not remove more
material than necessary.
G
J
H
N