Seiki SK1100T, User Manual

Page: 18 / 24

Seiki Cutting Plotter
15
Section V Troubleshooting Guide
Q1. Why is the pattern deformed or incomplete?
Reasons:
1.
Maybe too much down force, blade extends too long,
too dirty block, too soft media, or the face of the
media is not smooth.
2. Maybe the blade can’t move freely in the holder,
clean the holder with alcohol.
3. When loading media, the pinch roller can’t be
pressed right on the grit roller.
4. The software doesn’t set properly.
Q2. Why machine didn’t get output?
Reasons:
1.
Check if the cutting plotter is well connected with the
computer.
2. Check the installation of interface in the output state.
Make clear it is COM1 or COM2 and make sure that
the interface of the menu should be correspondent to
that of the computer connected to the cutting plotter.
3. Reinstall software if there is any problem with
software.
Q3. Why does the machine run abnormally?
Reasons:
1.
the software setting isn’t proper
2. the cutting software has been damage by virus in
computer
3. the protection function isn’t closed
4. the out device selection doesn’t match to the Seiki
cutting plotter