Assembling the Trekker PT
Trekker PT
Page 6
6.4 Mount the Handlebar and Leansteer Frame
Insert the handlebar into the leansteer frame and secure with 3 x 3mm hex screws; use a hex wrench to
tighten. Insert the handlebar into the leansteer frame and tighten the adjuster nut. Insert the leansteer
frame into the main frame and tighten.
6.5 Install the Battery Pack
Lay the Trekker PT forward on to the ground, protected by a blanket or foam
to prevent scratching the mainframe, and take out the M4 x 10 hex screws of
the battery housing using a 3mm wrench Insert the batteries into the
chassis, and replace all screws with hex wrench.
Note: With dual battery packs, the lower battery is the backup battery. It is
not recommended to remove this for separate charging, as it can be difficult
for users to uninstall.
2
3
1
