Segway PT i2, Reference Manual

Page: 134 / 160

122
Segway PT Will Not Power On
Your Segway PT will not power on when you press the InfoKey
Controller Power/Standby button. The procedure below will help you
determine if you are standing in range for the InfoKey Controller to
communicate with the Segway PT, whether the InfoKey Controller
Battery needs replacement, whether your Segway PT needs to be
“reset” by removing and reattaching the Batteries, or if you are
experiencing a startup error.
You should review the following service procedures prior to
troubleshooting this problem for important instructions and torque
values.
z
“Removing the Batteries” on page 100
z
“Reattaching the Batteries” on page 102
z
“Replacing the InfoKey Controller Battery” on page 110
Recommended Action:
1. Make sure your Segway PT's Batteries are charged.
2. Make sure you are standing with the InfoKey Controller no further
than 15 ft. (5m) from your Segway PT.
3. Tap the InfoKey Controller Power/Standby button and verify that
the Link Signal icon appears in the InfoKey display.
4. For more information, see “InfoKey Controller” on page 19 .
5. If no Link Signal icon is displayed or the display is blank (no
information displayed), remove and reseat the InfoKey Battery.
6. Tap the InfoKey Controller Power/Standby button. If the InfoKey
display is blank, replace the InfoKey Controller Battery.
7. If the Warning icon appears (see “InfoKey Controller” on page
19 ) in the InfoKey Display when attempting to power on, see
“Startup Error Conditions” on page 130 .
8. If your Segway PT will still not power on, remove both Batteries
and then reattach them.