Sega Virtua Tennis 4, Owner'S Manual

Page: 103 / 136

94
GAME BOARD
16
● To prevent electric shock or IC Board malfunctioning, be sure to turn off the
power for the cabinet when installing or removing the IC Board.
● Extraneous matter such as dust on the IC Board can cause the IC Board to
generate heat and result in a fire due to short circuit, etc. Ensure the IC Board
surfaces are always kept clean.
● Keep the IC board well cooled. RINGEDGE is provided with ventilating fans. Do
not block the air outlets of these fans. Also do not place anything closely to
RINGWIDE. Failure to observe these instructions may cause an overheating and
fire.
● Always follow the usage conditions from SEGA as well as the usage conditions
for the cabinet you are using for RINGEDGE. Failure to do so may cause an
overheating and fire.
● To avoid an electric shock or malfunctioning, do not pull out the power cord
while the power is on.
● To avoid an electric shock or malfunctioning, do not touch the power input port
with a wet hand.
● To avoid causing a fire or an electric shock, do not put things on or damage
the power cords.
● When, or after installing the product, do not unnecessarily pull the power cord.
If damaged, the power cord can cause a fire or an electric shock.
● In case the power cord is damaged, ask for a replacement through where the
product was purchased from or the office herein stated. Using the cord as is
damaged can cause fire, an electric shock or leakage.
16-1 HANDLING PRECAUTIONS
● Be sure to connect the IC Board and connectors completely. Insufficient
insertion can damage IC Board, etc.
● For the IC Board circuit inspection, only the use of Logic Tester is permitted. The
use of ordinary testers is not permitted as these can damage the IC Board.
● Do not subject the IC Board to static electricity when installing the IC Board in
the cabinet or when connecting wire harness connectors to the IC Board.
● When soldering buttons, etc. to the wire harnesses, be sure to remove the wire
harnesses from the IC Board so as not to subject the IC Board to heat.
● Some parts are the ones designed and manufactured not specifically for this
product. The manufacturers may discontinue, or change the specifications of,
such general-purpose parts. If this is the case, SEGA cannot repair or replace a
failed product whether or not a warranty period has expired.