Sega Racing Classic, Owner'S Manual

Page: 49 / 166

40
EXPLANATION OF TEST AND DATA DISPLAY
9-3-5 DRIVE BD TEST
1
On the GAME TEST MODE screen, select DRIVE BD TEST and press the TEST Button. The DRIVE
BD TEST screen appears.
This screen is for checking the steering wheel's force feedback.
Periodically use this screen to check that the steering wheel's force feedback is operating normally.
2
Each item is explained below.
Move the cursor up and down with the SERVICE Button or the VR1 (red) and VR2 (blue) buttons. The steering
wheel will move to the setting selected with the cursor. The VR3 (yellow) and VR4 (green) buttons can be used to
increase or decrease the force transmitted to the steering wheel.
SPRING Disables the motor and clutch in the recoil mechanism.
The steering wheel will be centered only by the internal spring.
CLUTCH Activates the clutch in the recoil mechanism. The steering wheel will be immobilized.
CENTERING Center the steering wheel.
UNCENTERING Disables centering of the steering wheel.
ROLL LEFT Turn the steering wheel left.
ROLL RIGHT Turn the steering wheel right.
STEERING VOL Displays the steering wheel volume value. Check to make sure the values are as
follows:
Appropriate volume values:
2DH or lower ← 7D - 83H → D3H or higher
(Left) (Center) (Right)
DIP SW Display the setting status of DIP SW on the DRIVE BD.
DRIVE BD TEST
SPRING
CLUTCH *---
CENTERING *---
UNCENTERING *---
ROLL LEFT *---
ROLL RIGHT *---
->EXIT
STEERING VOL **H
1 2 3 4 5 6 7 8
DIP SWITCH
OFF OFF OFF OFF OFF OFF OFF OFF
SELECT WITH SERVICE BUTTON AND PRESS TEST BUTTON
9