「
Mushiking#3-eng.doc
」
最終印刷日時：
2010/01/14 14:19:00
10/17
Clean the CRT surface and the monitor cover once a week. Apply antistat after cleaning.
1. Turn off the main AC unit power switch.
2. Remove the 7 truss screws and detach the monitor cover.
3. The monitor (CRT) will be exposed. Use an untreated soft cloth to wipe off both the CRT surface and the
monitor cover.
4. After cleaning, spray antistat onto the CRT and the monitor side of the monitor cover.
FIG. 15-2
1) TRUSS SCREW (3), chrome / M4 x 14; (reverse side of monitor cover) M4 NUT/WASHER STOPPER
2) TRUSS SCREW (4), chrome / M4 x 12
3) MONITOR COVER
(P. 52)
15-3 MONITOR ADJUSTMENT
[!] WARNING
●
Monitor adjustments have been made at the time of shipment. Therefore, do
not make further adjustments without a justifiable reason. Adjusting the monitor
containing high-tension parts is dangerous. Also, an improper adjustment can
cause deviated synchronization and image fault, resulting in malfunctioning.
●
When making monitor adjustments, use a resin regulating rod. Using bare
hands or conductive tools can cause electrocution.
●
Be sure to perform appropriate adjustments of the monitor. When operating
this machine, do not leave the monitor's flickering or deviation unchecked.
Failure to observe this can worsen the players' or the customers' physical
conditions.
●
Do not touch undesignated places. They can cause electric shock or short
circuit.
The monitor regulation board is located on the lower part of the monitor.
DESCRIPTION OF ADJUSTMENT KNOBS
FIG. 15-3a
