Sega Luigi's Mansion Arcade, Owner'S Service Manual

Page: 21 / 214

PRECAUTIONS REGARDING INST
ALLA
TION LOCA
TION
7
2
To install this product, the entrance must be at least 0.8m in width and 1.95m
in height.
Do not attempt to move the product by pushing or pulling on the plastic
parts. This may damage the product and my cause personal injury.
• For the operation this machine, secure a minimum area of 3m (W) x 3.5m (D).
These dimensions are necessary to enable the customer to walk around the
machine and also to provide adequate ventilation. The player is required
to be physically active when playing this game, so there is a possibility of a
player falling, so be sure to secure the minimum area around the machine
specified in this manual.
• Be sure to provide sufficient space specified in this manual. Do not allow
objects to block the ventilation ports. It can cause generation of heat which in
turn may cause a fire hazard.
• SEGA shall not be held responsible for damage or compensation for damage
to a third party, resulting from the failure to observe this instruction.
• If the machine does not fit through the entryway to the installation location,
do not disassemble it without first consulting the instructions. The machine
should only be disassembled in accordance with the instructions listed in
this manual; do not attempt to disassemble it in any other way. Specific tools
and adjustment procedures are required to assemble and disassemble the
mechanical parts. Attempting to assemble or disassemble the machine
without consulting the instructions may result in accidents during assembly/
disassembly and electric shock, short circuits, and/or personal injury during
operation. If the machine still does not fit through the entryway after following
the procedures in this manual, contact your retailer or the office listed in this
manual.
• If the machine is still too large to fit through the entryway after following the
procedures listed in this manual, do not tip the machine on its side. Attempting
to transport the machine while it is tipped on its side may cause accidents. It
may also damage or warp parts of the machine, resulting in accidents during
operation.
• To install this product, the entrance must be at least 0.8m in width and 1.95m in
height. If the entrance is too narrow, do not tilt the product carelessly. If all the
product weight is put on the casters at one side only, there could be damage
or deformation, causing serious accidents such as workers getting caught
underneath.
2-2 OPERATION AREA