Sega House of the Dead, Operator'S Manual

Page: 31 / 59

Shooting the 2 grid displays "NOW
CALCULATING" on the center of the screen to
allow sighting to be adjusted. Next, the gun mark
checking screen shown left appears. When the
controller is pointed to the screen, the gun mark is
shown on the screen. The mark position shows the
gunshot. If this adjustment is satisfactory, press either
the TEST BUTTON or 1P side START BUTTON.
When readjusting, press either the SERVICE
BUTTON or 2P side START BUTTON.
Choosing PLAYER 1 GUN DEFAULT ADJUSTMENT causes the
screen shown at left to be displayed. The sighting is reset to the
initial setting made at the time of shipment from the factory.
However, due to some changes in the unit's environment and cabinet
after shipment, sighting may not always be accurate. To reset to the
initial setting, press the TEST BUTTON or 1P side START
BUTTON. To return to the sighting adjustment menu without doing
anything, press the SERVICE BUTTON or 2P START BUTTON.
Select PLAYER 1 GUN MANUAL ADJUSTMENT to cause the
screen shown at the left to be displayed. In this screen, the 4
adjustment values can be set. Use this adjustment mode only when
accurate sighting can not be achieved in the above 2 screens. When
setting each of the 4 adjustment values, follow the procedure below:
Be sure to shoot at the screen's end portion in the designated
direction and determine the adjustment value by paying attention to
the impact mark movement.