IV. Wall Mount Installation Connection
Notice:
1.
Installation should be made by a qualified technician.
2.
For detailed connection information, please refer to silk-screen print instruction on PCB
and installation guide or manuals.
3.
Because the dome is a high-grade optical unit, please never touch any of the optical
components, avoid scratching the dome, for fear that affect the image definition quality.
4.
For a clear image, the dome cover should be cleaned periodically. When cleaning,
position your hand to hold dome’s outer loop to prevent finger sweat acidity from
corrupting the surface of the dome. If the dome is scratched, it will affect image quality.
Therefore please use a soft dry cloth or similar products to clean its outer surface. If the
dust is heavy, you can use a neutral cleanser. Any advanced furniture cleanser can be
used to clean the dome exterior.
5.
Please keep complete air proof in outdoor installation, avoiding moisture.
4.1 Dome Camera Wall Mount Installation
4.1.1 Wall Mount Bracket and Cover Installation
Note:
Installation locations should endure 5 times weight of total weight (dome camera,
mounting bracket and mounting base) to avoid shaken images.
a.
Set wall mounting bracket on the wall. Draw out mount holes on the wall against bracket
sample.
b.
Use drill to make 4 holes at the designated location. Screw in M8 bolt for mounting.
c.
Cut power, communication and video lines through bracket hole, leaving enough wire
length.
d.
Fix the bracket to the wall with 4 M8 bolts and mounting gasket.
4.1.2 Wire Connection
a.
Loose the screws on the dome cover and open the cover.
b.
Connect BNC video interface of speed dome camera with video wire (BNC). Connect the
power supply interface with the ready power supply line. Connect the RS485 interface with
the ready RS485 control line. Then replace the cover after examination.
Notice:
Do not connect positive and negative polarity of RS485 contrarily. (A: RS485 positive,
B: RS 485 negative polarity.) If RS485 is connected contrarily, the dome cannot be controlled.
4.1.3 Core Mounting
a.
Set the DIP switches for SW1 and SW2 on the bottom of the dome drive for the appropriate receiver
address.
b.
Line up the green and red tabs with the green and the red labels. Push in on the tabs. Insert the side
15
