III Dome Camera Installation and Setting
3.1. Dome Camera Controlling
Notice:
To assure the normal signal communication, a 120 ohm R should be connected to the
farthest dome when one control bus control more than two domes.
3.2. SW1 Switch Setting
Note: SW1 switch is used for setting communication protocol.
ON=1
，
OFF=0
Protocol
Switch Setting
SW1-1 SW1-2 SW1-3 SW1-4 SW1-5 SW1-6 SW1-7 SW1-8
Matrix
Protocol
（
9600
）
0 0 0 0 0 0 0 0
PELCO-P
Protocol
1 0 0 0 0 0 0 0
PELCO-D
Protocol
（
2400
）
0 1 0 0 0 0 0 0
3.3. SW2 Switch Setting (PELCO-P/PELCO-D)
Note
: SW2 switch is used for setting the receiving address and baud rate.
It is effective only in PELCO-P/PELCO-D protocol
ON
=1
，
OFF
=0
6
