32
9. Dismantling/Reassembly of the pump
D / 26.10.2017 - OM.MAI.84EN - 4/6
9.1.3
Assemble pump
9.1.3.1 Assemble drive (ANT)
9.1.3.2 Assemble rotor (600), coupling rod (400) and plug-in shaft (307)
9.1.3.3 Assemble rotating unit (RTE)
Risk of injury due to lack of stability of
pump. Crushing of body parts due to the pump or
pump parts tipping or falling down.
Design with base plate
Fasten base plate
(GPU)
to secure pump.
–
Recommendation: Fasten to suitable base
using a screw fitting
(SCH)
.
Design without base plate
Fasten lantern
(200)
to secure the pump.
–
Recommendation: Fasten to suitable base
using a screw fitting
(SCH)
.
Clean flange bearing surfaces
(FLS)
, centering
surface
(ZD)
and output shaft of the drive
(ANT)
.
Assemble drive
(ANT)
with screw fitting
(210,
212, 213)
on lantern
(200)
.
Joint
(G)
reassembly note rotating unit -
individual parts (
chapter 9.2).
Slide shaft seal casing
(SEA)
onto plug-in shaft
(307)
.
–
Observe instructions for shaft seal
reassembly (
chapter 9.4).
Coat inner surface of splash ring
(310)
and outer
surface of plug-in shaft
(307)
with anti-seize
graphite petroleum
(GC)
for easier assembly of
the splash ring
(310)
.
Slide splash ring
(310)
onto plug-in shaft
(307)
.
–
Observe fitting position of splash ring
(E)
(let-
tering „SEA“).
