DropLit Assembly Guide
Now you need to install the black & yellow power wires into the two position terminal block
along the edge of the gShield. The black wires go into the position marked “GND” and the yellow
wires go into the position marked “Vmot”. Please trim your wire a bit so that little or no wire is visible
outside the face of the terminal block. (In other words, DO IT BETTER THAN I DID!)
Now insert the four stepper wires
into the “Z” position on the gShield, just
as you see them on the right. Note that
this terminal block uses a very small flat
tip screwdriver!
62
Fig. 6-26: Power wires installed.
Fig. 6-27: Stepper wires installed.
