6
|
MAGIQTOUCH & MAGIQCOOL MODELS
MAGIQTOUCH CONTROLLER
With a touch screen user interface and inbuilt
temperature sensor, the MagIQtouch controller
will operate Seeley International’s new range
of Breezair and Braemar models, including
EXQ, EZQ, EXS, LCQ and LCS models. BMQ
and CPQ coolers can be upgraded to the fully
featured MagIQtouch controller.
The MagIQtouch controller can be used on its
own to operate an evaporative cooler.
ILL1521-B
ILL1828-A
ILL1831-A
A single MagIQtouch controller can also be
used with a MagIQtouch Air Sensor, which
provides more flexibility with the mounting
location of the controller.
MOUNTING LOCATION
The MagIQtouch controller, with in-built
temperature sensor, should be placed
approximately 1.5m above the floor, in the
most used room of the home.
Placement is critical for correct functioning of
the temperature sensing thermostat inside the
controller.
The following points must be taken into
consideration:
• Avoid direct sunlight exposure.
• Avoid mounting on external walls.
• Avoid mounting the wall control near heat sources
such as stoves and televisions.
•
Do not locate in the direct airflow of the duct
outlets.
• Do not locate in strong drafts or in dead spots such
as cupboards/drawers.
• Always seal the cable entry hole. Hot or cold air
coming through the wall may interfere with the
temperature measurement.
If a MagIQtouch Air Sensor is to be installed
with a single controller, the above location
instructions should be applied to the Air
Sensor. In this case, the controller location is
not important.
CAUTION!
Always make sure there are no
electrical cables, gas or water pipes, or the
like, behind where you intend to drill.
CABLE LENGTHS
The maximum recommended cable length is
25m from MagIQtouch controller to first cooler.
This is to ensure adequate power is delivered
to the controller for correct operation.
ILL1759-C
