Front Panel Menu Operation
22
Device/Circuit Bypass
Use this option if you want to bypass or unbypass a device or circuit from the panel. Usually this is done when you
need to add, remove, repair, or investigate a device or circuit.
To unbypass the device or circuit, follow the same procedure for device/circuit bypass.
At this point the display will vary, depending on your choice:
•
If you selected “yes”,
the system will display the message “Device/Circuit bypassed (unbypassed), then it will
return to the Bypass Menu.
•
If you selected “no”,
the system will display the message “Operation cancelled”, then it will return to the
Bypass Menu.
Step 1: Select Device/Circuit
Press
when the cursor is flashing beside
“Device/Circuit” to select a device.
Step 2: Enter your passcode
Enter your passcode.
See page 10 for instructions on
entering passcodes.
Step 3: Select a device
1. Use
and
to select the node, loop and
device number.
2. Enter the node number, then press
.
3. Enter the loop number, then press
.
4. Enter the device number, pressing
and
as needed to move left and right.
5. Press to
continue.
Step 4: Bypass the device/circuit
1. The systems now asks you whether or not you would
like to bypass or unbypass the device. Use
and
to select “yes” or “no”.
2. Press
to continue.
- Bypass Menu -
1 Device /Circuit
2 Relay Disc
3 Input Zone
Enter passcode for
level 1 or higher:
- Select Device -
Node: 0
Loop: 0
Device: 0 0 0
Strobe Output
Floor 2
L0 000 not
bypassed. Bypass? Y