ST-HDoC / ST-HDoC-MM
1
1. Safety information
◆
The ST-HDoC/ ST-HDoC-MM is intended for use in compliance with applicable codes and
laws.
◆
Do not expose to moisture.
◆
Do not drop.
◆
The tester should not be charged over 8 hours.
◆
The tester should not be used in an environment with any flammable gas or chemicals.
◆
Do not disassemble the tester except to change the battery.
◆
Don’t use any chemical cleaning products to clean the test meter. Use a dry cloth.
1.1 Digital Multi-meter Safety
◆
Prior to taking any measurements, be sure you are using the correct range, function and input
jack. Red is positive, black is negative.
◆
Never exceed the protection limit value for each range of measurement.
◆
While measuring a live circuit, do not touch any unused terminals.
◆
If the value to be measured is unknown while using the manual range, set the range selector to
the highest position.
◆
Always be careful when working with AC or DC voltages since you could be injured or killed
by voltage going through your body. Keep your fingers behind the probe barriers while
measuring. Do not touch the metal probes while taking any measurements.
◆
Never perform any capacitance measurements unless the capacitor has been fully discharged.
2. Introduction
2.1 General
The 3.5 inch touch screen HD camera monitor and tester, is designed for maintenance and installation
of HD over Coax and analog cameras as well as other security equipment. The 480X320 resolution
enables it to display HD cameras and analog cameras in high resolution. The unit supports many HD
over Coax technologies including HDCVI, TVI, and AHD.
