ST-HDoC / ST-HDoC-MM
15
A. Protocol
Use the up and down arrow keys to move the yellow cursor to
the “
protocol
” function, from here, you can set the
corresponding Protocol. The tester supports more than 30
different protocols, including Pelco, Samsung, Bosch, etc.
B.
Port
The default port for the ST-HDoC is set to RS485 for analog PTZ cameras, with UTC protocols being
embedded in the corresponding HDoC app.
C.
Baud
Move the yellow cursor to “Baud” function, select the baud rate according to baud rate of the PTZ
camera.(600/1200/2400/4800/9600/19200/57600/115200bps)
D. Address
Set the ID according the ID of PTZ camera (0~254), the address settings must be consistent with that of
the PTZ camera being tested.
E.
Pan speed:
Set the pan speed of the PTZ camera (0~63)
F. Tilt speed:
Set the tilt speed of PTZ the camera (0~63)
G. Set preset position (Set PS)
Move the yellow cursor to “SET PS”, to save the preset position number (1~128), Press the
key
To accelerate the value change, then press the key to save.
H.
Call the preset position (Go PS)
Move the yellow cursor to “Set PS”, then enter the desired preset position (1~128),
Press the key or to accelerate the value changing.
Press the key to complete preset position settings.
*Some PTZ cameras require special preset numbers to call specific menus/ functions.
Check and set the protocol, address, interface and baud rate, that they are the same as the dome camera,
then you can test and control the PTZ camera.
